LOWER ROLL ASSEMBLY INSTALLATION
FOR 3/4-INCH/26.9-MM AND 1 TO
1 1/2-INCH/33.7 TO 48.3-MM SIZES
1.
Clean the bore of the main shaft and the
lower roll assembly with a soft cloth.
2.
Apply a light coating of mechanical
assembly spray (supplied with the tool) to
the lower roll assembly.
3a.
Insert the lower roll assembly carefully into
the main shaft, making sure it is seated
fully. It may be necessary to rotate the
lower roll assembly to align its square back
end with the main shaft.
3b.
With a wrench engaged on the square end
of the lower roll assembly, tighten the lower
roll assembly by turning
counterclockwise
.
ARBOR INSTALLATION PROCEDURE FOR
2-INCH/60.3-MM AND LARGER SIZES
1.
Clean the bore of the main shaft and the
arbor with a soft cloth.
2.
Apply a light coating of mechanical
assembly spray (supplied with the tool) to
the lower roll assembly.
3a.
Insert the arbor carefully into the main
shaft, making sure it is seated fully. It may
be necessary to rotate the arbor to align its
square back end with the main shaft.
3b.
With a wrench engaged on the cap screw
portion of the stud, tighten the stud by
turning
clockwise
. The arbor should move
inward as the stud is tightened.
TM-VE268_35
REV_H
TM-VE268
/ Operating and Maintenance Instructions Manual
