PM290 - DIGITAL RECTIFIER
Models: 270.10
Impulse Power Supply - Precision current & voltage
regulator. Self-restore internal short circuit protection.
Works under maximum loads for extended periods - Dual
voltage 110V/230V, 50-60Hz.
User’s manual
Features
1. General
specifications
INPUT: 115V AC, 5A max., 60Hz; 230V AC, 2.5A
max., 50Hz
OUTPUT: 12.6V DC, 12A max
Efficiency not less than 85%
Short circuit protection self-restoring after elimination of short circuit
Range of operating temper 5°C min, + 40°C max
Overall dimensions 100
х
236
х
225 mm
Mass 1.9 kg max
2. The mode of voltage stabilization
Display of operating conditions light, green
Range of output voltage adjustment 1.2V min, 12.6V max
Precision of output voltage adjustment 0.1V
Amplitude of output impulse voltage 0.1V max
Instability of output terminal voltage (Depends on time and external factors) not more than 1%
3. The mode of current stabilization
Display of operating conditions light, red
Range of output current adjustment 0-10A
Precision of output current adjustment 0.1A
Amplitude of output impulse voltage under maximum load not more than 0.2V
Instability of load current (depends on time and external factors) - not more than 1.5%
Basic Operations
Connecting to AC source
1. Place the Power Supply on horizontal, stable surface avoiding direct sunshine.
2. Place the Power Supply at least 10 cm away from the walls for good air circulation.
3. Check the correspondence of the position of input voltage value switch to the specifications of AC circuit,
to which you connect the Power Supply.
In case there is no such correspondence the Power Supply may be damaged.
Do not use the DC or another AC which does not correspond 110-120V or 200 – 240V, 50-60Hz.
4. Put the AC cord into the socket on the backside of the Power Supply.
“ON”
Check the correspondence of the position of input voltage value switch to the specifications of the network.
1. Plug the AC cord into the outlet.
2. Connect the load to the output terminals with the help of DC cable.
3. Put the voltage and current regulators into the extreme left position.
4. Put the power switch into the position “ON”.
Voltage stabilization mode
