Vertiv VRC-S, Руководство пользователя

Страница: 30 / 66

Item Description
1 Condensate pump shroud
2 Condensate pump power cord
3 Geist rPDU locking receptacle
4 Condensate pump power cord plugged in
5 Condensate pump symbol on Geist rPDU to indicate proper power connection
Table 4.2 Condensate Pump Power Cord Routing, Connection Descriptions
4.8 Attach the Local Display
A local display and two communication cables are included in the Vertiv™ VRC kit. The display permits checking
conditions in the rack without opening a door or using a network computer. (The Geist™ rPDU is network-enabled and
permits monitoring and managing the Vertiv VRC's operation over your network.)
The local display may be installed on either the door or laid on the Vertiv VRC. If the display is to be placed on the cooling
unit, simply attach the 20in. (50cm) communication cable to the rack and to the rear of the cooling unit as shown Figure 4.6
below .
IMPORTANT! Vertiv recommends installing the display in the opening fabricated in the rear door.
To install the local display on the door:
1. Remove the magnetic case from the display by extracting the four screws holding the assembly together.
2. Insert the display into the cutout on the rear door of the Vertiv™ VR and secure it with the four screws removed
in Step 1 .
3. Connect the 32 ft. (10m) display cable to the display and route it around the top of the exhaust fan and to the
Vertiv VRC.
4. Plug the cable into the Vertiv VRC as shown in Figure 4.6 below .
Figure 4.6 Display Cable Attachment and Connections
4 Installation
26
Vertiv™ VRC-S User Manual