versa ag leader, Руководство оператора

Страница: 237 / 304

223
A
PPLICATION
I
NJECTION
D
ISCHARGE
F
LOW
S
ENSOR
P
IN
O
UTS
Direct Injection: Inlet Restriction
The injection pump has a vacuum switch that is used to warn operators of any
restriction at the inlet of the pump. The sensor is a normally closed switch that
opens if a restriction is encountered in the injection system. A warning will be
displayed for the operator if the vacuum switch opens due to restriction. See
table below for pin locations. The operator can test the system by unplugging
the sensor, which will trigger the warning. If the operator jumps pins A and C,
the warning will end.
V
ACUUM
S
WITCH
P
IN
O
UTS
Controller Settings: Direct Injection Pump Calibration
Pump Calibration Setting
• Factory Calibration
The Factory Calibration Number is found on the tag of the Digital Pump Speed Sensor. This tag number
represents pulses per 10 fluid ounces. Divide the tag number by 10 and enter this number. Once entered,
this number should not be changed.
• Perform Calibration
Press the Perform Calibration button to begin the calibration procedure for the Direct Injection pump. The
pump will not run until this calibration has been performed.
Module Auxiliary Connection 12-
Pin Socket
3-Pin WP Shroud
Power (12V) 11 A
Signal 9 B
Ground 8 C
Module Auxiliary Connection 12-
Pin Socket
3-Pin WP Shroud
Power (12V) 2 C
Signal 10 A
Make sure 3 way
valve is in operate
Check for plugged
strainer on the inlet of
Refer to injection pump
manual to test vacuum