16
20304166
VCFDVI31 Gas Fireplace Insert
INstAllAtION
7. Run flexible fuel line from valve through one of the two
openings located in upper right rear corner of the insert
firebox.
Figure 17
FP2972
fuel line
Flexible Fuel Line
FP2972
Figure 17 -
Flexible Fuel Line Location
8. Locate the black and white wires marked 'BLOWER'
on the rear of the control board. Connect the female
terminals to the male terminals (coming from the blow-
ers) at the bottom right rear corner of the insert.
Figure
18
9. Locate the black and white wires marked 'LIGHT'.
Connect the female terminals to the male terminals
coming from the overhead light.
Figure 18
FP2973
wires
Figure 18
FP2973
10. To connect the three-pronged electric cord, remove the
plastic grommet from lower right side corner of insert.
Insert plug end of electric cord through hole in insert
and through plastic grommet. Slide grommet down
electrical cord and reinstall.
Figure 19
FP2974
grommet
Plastic Grommet
FP2974
Figure 19 -
Remove Plastic Grommet
11. Take command center cable disconnected in Step 3
and insert pin connector and loose end of cable to
the inside of the outer wrapper. Reconnect the six-pin
connector to the control board. With the buttons and
switch of the command center to the left, insert the
command center into the bracket on the lower right
corner of insert by sliding grooves on outer housing
of command center into the two (2) protrusions on the
bracket.
Figure 20
FP2975
pin connector
Figure 20
FP2975
12. Make sure all cables, wires, lines, etc. are inside the
cavity of the outer shell of the insert. Reinstall the panel
removed in Step 1.
13. You may now plug in the electrical cord and attach the
flexible fuel line to the incoming gas supply line.
