20304166
VCFDVI31 Gas Fireplace Insert
17
INstAllAtION
Fp2976
SCS Bracket
Command
Center
Command Center Bracket
FP2976
Figure 21 -
Install Command Center into
Command Center Bracket
lOG suppORt INstAllAtION
1. Remove log support bracket and grate from packaging
in the engine assembly/log box.
2. Install log support bracket by installing two (2) screws
provided into holes in rear wall of insert chamber. Install
one (1) screw into hole in left and right sides of insert
chamber.
Figure 22
BRICK pANel INstAllAtION
Figure 23
Kit contents:
1, Rear Panel
2, Upper Brick Retainer Brackets
1, Left Panel
2, Lower Brick Retainer Brackets
1, Right Panel
2, Front Brick Retainer Brackets
4, Self-tapping Screws
1. Remove brick panels and retainers from packaging.
2. Remove two (2) screws on each side of front edge of
chamber.
3. Install one (1) front brick retainer bracket on each side
with the screws removed in Step 2.
4. Carefully set rear brick panel with notch up on log sup-
port.
5. Carefully place right or left side brick panel in place
making sure front edge of brick is behind the front brick
retainer bracket.
6. Using self-tapping screw, install upper brick retainer
bracket (with two (2) holes and slot with the long side
down into the top of the inner chamber.
7. Using self-tapping screw, install lower brick retainer
bracket (smaller bracket) into the log support bracket
centered on brick panel.
8. Repeat Steps 6 & 7 for remaining side.
FP2981
log support
Log Support
Mounting Holes
Log Support
with Grate
FP2981
Figure 22
FP2982
install brick panels
Remove Screws
Rear Brick Panel
with Notch Up
Upper Brick
Retainer Bracket
Lower Brick
Retainer
Bracket
Front Brick
Retainer
Right Brick
Panel
Left Brick
Panel
FP2982
Figure 23 -
Install Brick Panels
IMpORtANt:
The fireplace must have an approved brick
kit or porcelain panel kit installed before operation.
