20304166
VCFDVI31 Gas Fireplace Insert
23
LG1131
ember material placement
LG1123
CFDVI embers
lOG plACeMeNt
Before you begin
- This unit is supplied with seven (7) ceramic fiber logs. Do not handle these logs with
your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling
the logs, wash your hands gently with soap and water to remove any traces of fibers.
the positioning of the logs is critical to the safe and clean operation of this heater.
sooting and other problems may result if the logs are not properly and firmly posi-
tioned in the appliance. Never add additional logs or embellishments such as pine
cones or vermiculite to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
INstAll lOGs AND ROCK WOOl (eMBeR MAteRIAl) IN FIReBOx
1. Break up rock wool (ember material) into small fluffy pieces. Place evenly as shown.
Refer to Figure
32.
2. Apply a light layer of embers to the ports.
NOte:
Excessive amount of embers will affect the flame
and the flame appearance.
NOte:
Embers may be added to entire burner area in front of grate to
hide burner and log support brackets.
Ember Material Area
LG1132
Figure 32 -
Ember Material Area
Do not use the entire bag
of rock wool to cover
burner area.
W
ARNING
W
ARNING
Ember Material
LG1123
Ember Material Area
