VERITAS 5250, Руководство по установке оборудования

Страница: 62 / 151

Input switch
Power on/standby (green/amber)
Module fault (PCM/cooling/ I/O) (amber)
Logical status (amber)
Unit identification
■
Verify that the Power on/standby LED is green.
■
If the Power LED or the other two LEDs are amber, escalate the issue.
■
The input switch is used to set the Unit identification (ID). The display is a
seven-segment display. You can reset the ID number. The values “01” to
“99” are valid. The value “00” is reserved.
“00” is also the default value.
■
Press the input switch and hold it down for five seconds.
The switch enters a programming mode. The digit on the left side of the
display begins to flash first. The flashes appear on for 0.5 seconds and
off for 0.5 seconds.
■
Press the input switch once to increment the number by one digit.
■
When your first required number is reached press the switch for five
seconds.
The first number is now locked.
■
Set the second number in the same manner that you set the first number.
If you do not want to set a second number press and hold the input
switch for five seconds.
The number “0” displays.
62 Installation procedures
Turning on the hardware and verifying operation