PRESSURE RELIEF PROCEDURE
1.
Place the ON/OFF Switch (B) into the OFF
position and unplug the power cord.
ALWAYS RELIVE PRESSURE WHEN
SPRAYING IS COMPLETED, AND
PRIOR TO CLEANING, SERVICING,
OR TRANSPORTING.
!
WARNING
RISK OF SKIN INJECTION. DO NOT
AIM THE GUN OR SPRAY AT ANY
PERSON OR ANIMAL. DO NOT PLACE
HAND IN FRONT OF SPRAY NOZZLE.
2.
Turn the Prime/Spray Switch to the PRIME
position.
Power Off
Always use a
Grounded
Pail
5.
Point the spray gun into the grounded waste or
solvent pail while holding any metal part of the
spray gun firmly to the side of the pail to maintain
ground continuity of the gun and pail, then operate
the trigger several times until pressure within the
hose has been relieved.
7.
Leave the Prime/Spray switch in the Prime position
until you are ready to spray again.
8.
If you suspect the spray tip or hose is clogged or
that pressure has not been fully relieved after
following these steps, CAREFULLY AND SLOW LY
loosen the tip guard retaining nut or hose end
coupling to relieve pressure gradually, then loosen
completely before attempting to clear the any
obstruction.
Prime
3.
Adjust the Pressure Control Knob (D) to the lowest
pressure setting (ROLL)
4.
W hen using a waste or solvent pail, ensure the pail
is metal and is properly grounded. Clamp one end
of a ground wire to the pail the other end to a
proper ground, such as a metal water pipe.
6.
Engage the trigger lock after pressure has been
relieved.
9
Locked
19802
V0.1
Содержание 19802
Страница 23: ...23 PARTS DIAGRAM 19802 V0 1...
Страница 25: ...25 NOTES 19802 V0 1...
Страница 26: ...26 NOTES V0 1 19802...
Страница 27: ...27 NOTES 19802 V0 1...