Vaper 19802, Инструкция по эксплуатации

Страница: 11 / 28

SETUP
11. Set the Pressure Control Knob (D) to the
Prime/Clean position.
Prime
12. Place the Spray/Prime Switch (F) to the Prime
Position.
Before each use, the sprayer must be primed and
flushed to remove the storage fluid out of the sprayer.
Follow these guidelines when priming and flushing:
•
Use water to thoroughly flush the system if you will
be spraying water-based materials.
•
Use a compatible oil-based flushing solvent or
mineral spirits to thoroughly flush the system if you
will be spraying oil-based materials.
•
If changing from oil
–based spraying to water-based
spraying, flush the system thoroughly with water
first. The water flowing out from the Primer Outlet
Tube (H) should be clear and free from any solvent
before you begin spraying the water-based material.
•
If changing from water-based spraying to oil-based
spraying, flush the system thoroughly with
compatible oil-based flushing solvent or mineral oil
first. The solvent flowing from the Primer Outlet
Tube (H) should not contain any water.
•
Always use a grounded metal waste or solvent pail.
See Electrical Safety section.
•
Always aim the gun at the inside wall of the waste
or solvent pail to avoid fluid splashing back on your
skin or into your eyes.
11
PRIME AND FLUSH
1. Turn the power ON / OFF Switch (B) to the OFF
position and unplug the sprayer.
2. Separate the Primer Output Tube (H) from the
Suction Tube (J).
3. Place the Primer Output Tube (H) into a grounded
waste / solvent pail and insert the Suction Tube (J)
with Inlet Screen (K) into a pail that contains water
or flushing solvent (determined by guideline
discussed above).
Prime
4. Check that the Spray/Prime Switch (F) is in the
Prime Position.
Power Off
19802
V0.1