Vaper 19802, Инструкция по эксплуатации

Страница: 16 / 28

16
CLEANING
NOTICE
CLEAN AFTER USE TO PREVENT PERMANENT
DAMAGE TO THE SPRAYER.
RETURNS NOT ACCEPTED & WARRANTY VOID IF SPRAYER IS NOT
PROPERLY CLEANED IMMEDIATELY AFTER EVERY USE.
USE THE CORRECT CLEANING FLUID
If the paint being used was water based (acrylic paint),
use ONLY W ATER when performing the cleaning
procedure.
NOTE: USING SOLVENT BASED CLEANING FLUID
ON W ATER BASED PAINTS W ILL RESULT IN A
SUBSTANCE THAT W ILL BE EXTREMELY
DIFFICULT TO CLEAN.
If the paint or coating material being used was oil
based (enamel paint, lacquer, etc.), refer to the coating
material’s label or MSDS to determine what solvent to
use. These solvent-based cleaning fluids are safe to
use in the airless sprayer:
•
Mineral Turpentine
•
Paint Thinner
CLEANING THE SPRAYER
1. Start cleaning the sprayer IMMEDIATELY after
use by following the
PRESSURE RELIEF PROCEDURE
on 9.
2. Use a wrench to remove the Nozzle Tip Guard (Q) and
Nozzle Spray Tip (P) from the gun and place it into the
cleaning fluid.
3. Separate the Primer Output Tube (H) from the
Suction Tube (J). Place the Primer Output Tube
(H) into a waste pail, and the Suction Tube with
Inlet Screen (K) into a pail that contains water or
flushing solvent (read section titled USE THE
CORRECT CLEANING FLUID discussed above)
Power On
6. Place the power ON / OFF Switch (B) to the ON
position.
Prime
4. Check that the Spray/Prime Switch (F) is in the
Prime Position.
5. Set the Pressure Control Knob (D) to the
Prime/Clean position.
7. Once a steady stream of cleaning fluid is flowing
from the Primer Output Tube (H), turn the Spray /
Prime Switch (F) to the Spray position.
Spray
V0.1
19802