Vaper 19802, Инструкция по эксплуатации

Страница: 17 / 28

17
8. Point the spray gun into the waste pail while
holding any metal part of the spray gun firmly to
the side of the pail to maintain ground continuity of
the gun and pail, then operate the trigger until the
only fluid exiting the gun is cleaning fluid.
9. Change the Spray/Prime Switch (F) to the Prime
Position, then repeat steps 7 and 8 until only
cleaning fluid is exiting the sprayer.
Prime
10. Place the ON/OFF Switch (B) into the OFF
position and unplug the power cord.
Suction Tube
(J) and
Power Off
CLEANING THE INLET HOSE
1. Remove the Inlet Screen (K) from the Suction
Tube (J) by loosening the hose clamp and moving
it away from the filter.
2. Pull the Inlet Screen (K) out and rinse using the
appropriate cleaning fluid.
) and
3. If the Inlet Screen (K) cannot be cleaned, replace
with a new Inlet Screen.
CLEANING THE SPRAY GUN
4. Use a pair of wrenches and remove the Inlet Port
(V) from the gun.
5. Move the handle guard out of the way and use a
wrench to remove the Handle (T) from the upper
body of the spray gun.
6. Remove the mesh filter from within the Handle (T)
and place it into the cleaning fluid.
7. Use a soft brush to clean all components in the
cleaning fluid.
8. Once cleaning is completed, reassemble the spray
gun.
1. Follow the
PRESSURE RELIEF PROCEDURE on 9.
2. Use a pair of wrenches and remove the High-
Pressure Hose (M) from the Spray Gun.
3. Use a wrench to remove the Nozzle Tip Guard (Q) and
Nozzle Spray Tip (P) from the gun and place it into the
cleaning fluid.
STORING THE SPRAYER
It is very important that the Sprayer is NOT stored with
water or water-based materials inside the pump, hose,
tubes, or spray gun. W ater remaining within these
items will cause corrosion and damage them. Follow
these procedures to store the sprayer.
19802
V0.1