10
1.
Insert the mesh filter into the Handle (T) and align
the handle with the upper body of the spray gun.
2.
W hile holding the upper body of the spray gun,
tighten the Handle (T) using a wrench.
3.
Place the handle guard over the hole on the
bottom of the handle, then secure in place using
the hose Inlet Port (V) adapter and two wrenches.
Items in parenthesis () refer to the Feature
Identification drawing in the previous section.
Note:
The spray gun comes assembled from the
factory. If the gun has been disassembled for cleaning,
follow the steps below to reassemble.
Mesh
Filter
A
B
C
D
4.
The Gun Tip and Guard consists of the following
components:
A.
Nozzle Tip Guard
B.
Nozzle Tip Guard Retaining Nut
C.
Metal Seat with Rubber Gasket
D.
Nozzle Spray Tip
5.
Use the Nozzle Spray Tip to install the Metal Seat
with Rubber Gasket into the Nozzle Tip Guard.
6.
Install the Nozzle Spray Tip into the Nozzle Tip
Guard.
7.
Thread the Nozzle Tip Guard Retaining Nut onto
the front of the upper spray gun body and tighten
with a wrench.
SETUP
9.
Connect the other end of the High-Pressure Paint
Hose (M) to the Gun Inlet Port (V) on the spray
gun Handle (T). Use a pair of wrenches to
correctly tighten the fitting.
10. Connect the Suction Tube (J) and Primer Output
Tube (H) to the back of the valve housing, then
install the Inlet Screen (K). Secure in place using
the supplied hose clamps.
8.
W ith the unit unplugged, uncoil and connect the
High-Pressure Paint Hose (M) to the Output Port
(E). Use a wrench to correctly tighten the fitting.
V0.1
19802
Содержание 19802
Страница 23: ...23 PARTS DIAGRAM 19802 V0 1...
Страница 25: ...25 NOTES 19802 V0 1...
Страница 26: ...26 NOTES V0 1 19802...
Страница 27: ...27 NOTES 19802 V0 1...