AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 5: OPERATION
090012-OP_r0
PAGE - 47
3. Continue turning control switch to the
START
position [
C
] until the engine starts (when the
switch is let go, it will revert back to
ON
position).
4. Let engine run at idle for a 3-5 minutes to
allow for warm up sequence.
5.2.2 ENGINE SHUTDOWN
Consult
Figure
5-1
. To shut the engine off at any time,
turn the engine control switch to the
OFF
position.
However, this method is best reserved for emergency
shutdown situations only. Vanair
®
recommends that the
following procedure is used for routine shutdowns in
order to keep the system in optimal condition, and
minimimize undue stress that may occur during the next
start up session if some of the machine conditions were
NOTE
Refer to Engine Operator’s Manual for
additional information pertaining to the
starting of the engine.
CAUTION
Compressors and engines generate heat
and create hot surfaces. Use caution
when operating and servicing
equipment. Some surfaces and
components may be hot.
Figure 5-3: Start-up Function Conditions
A
A
B
C
A
Содержание 050518
