Vanair 050518, Руководство по эксплуатации и список запасных частей

Страница: 86 / 210

SECTION 6: MAINTENANCE AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 68 090012-OP_r0
Refer to Figure 6-2 and the following procedure:
STEP 1 - REMOVE BOLTS MOUNTING BACK PANEL
TO BASE FRAME
Refer to inset [ A ] in Figure 6-2 .
1. Remove the four (4) bolts [ A
1
] and four (4)
washers [ A
2
] fastening the lower edge of the
back panel to the base frame.
STEP 2 - FREE THE RIGHT SIDE PANEL FROM THE
BASE FRAME
Refer to inset [ B ] in Figure 6-2 , which shows the lower
right side of the machine package.
1. Facing the base frame right-side base cover
[ B
1
], remove the truss screw [ B
2
] and
washer [ B
3
] fastening the base cover at the
left side. Remove these same fasteners ( B
1
& B
2
) connecting the base cover’s upper
right side as well.
MAINTENANCE ISSUE
SECTION
LOCATION
Compressor oil filter (easier to access with
panels removed) 6.6.4
Engine Oil Filter Change
I
Engine Drive Belt Replacement
I
Engine Hydraulic Pump Drive Belt
Replacement 6.6.15.5
Pressure Switch Adjustment 6.6.14
Main Cooler Assembly Cleaning (thorough) 6.6.11
Replace Fuses and Circuit Breakers 6.7
Generator Fuse Replacement 6.7
I
Refer to the Engine Operator’s Manual.
WARNING
Make certain that the machine is off, and
the ignition key removed before
attempting this procedure.