Vanair 050518, Руководство по эксплуатации и список запасных частей

Страница: 127 / 210

AIR IN ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 7: TROUBLESHOOTING
090012-OP_r0 PAGE - 109
COMPRESSOR (CONTINUED)
Compressor overheats (continued)
This condition will cause a
compressor shutdown and
compressor fault light to turn
on. Before restarting the
compressor, determine the
cause for overheating.
Insufficient air flow over cooler Check for obstructions (frame, body, etc.) to
cooling air flow.
Defective temperature switch Check switch; replace if necessary.
Compressor oil filter plugged Replace filter; refer to Section 6.6.4,
Replacing the Compressor Oil Filter
Element
.
Input rpm too high Adjust to proper setting; refer to Section
6.6.13, Adjusting the Engine Speed , and
the Engine Operator’s Manual.
Fan not operating Low oil; check oil level and refill to proper
level if necessary (ensure machine is
parked on a level surface). Refer to
Section
6.6.3, Checking the Compressor Oil .
Belt slip on hydraulic pump. Refer to
Section 6.6.15.5 or Section 6.6.15.6 .
Compressor shuts down with air
demand present Compressor temperature switch
opening Check compressor oil level. Replenish if
necessary.
Restricted cooling air intake Reposition machine.
Fan not operating Low oil; check oil level and refill to proper
level if necessary (ensure machine is
parked on a level surface). Refer to
Section
6.6.3, Checking the Compressor Oil .
Belt slip on hydraulic pump. Refer to
Section 6.6.15.5 or Section 6.6.15.6 .
Compressor oil filter plugged Replace filter; refer to Section 6.6.4,
Replacing the Compressor Oil Filter
Element
.
Clutch faulty Inspect; replace if necessary.
Plugged or restricted cooler core Flush cooler. Consult the Vanair Service
Department for assistance in cleaning/
flushing the cooler core.
Contaminated cooler fins Clean cooler fins. Refer to Section 6.6.11,
Inspecting the System Coolers .
Compressor will not build up
pressure Low compressor oil level Check oil level and refill to proper level if
necessary (ensure machine is parked on a
level surface). Refer to
Section 6.6.3,
Checking the Compressor Oil .
Continued on next page
7.2 TROUBLESHOOTING GUIDE
Fault/Malfunction Possible Cause Corrective Action