Vanair 050518, Руководство по эксплуатации и список запасных частей

Страница: 87 / 210

AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090012-OP_r0 PAGE - 69
2. Remove the three (3) truss screws [ B
4
] and
three (3) washers [ B
5
] from the bottom edge
of the base cover [ B
1
].
3. Set the base cover [ B
1
] and hardware aside.
4. Remove the four (4) serrated washer screws
[ B
6
] fastening the right-side panel [ J ] to the
base frame.
STEP 3 - REMOVE THE CROSS BRACE SUPPORTS
AT BACK LEFT AND FRONT RIGHT
CORNERS
Refer to both insets [ C ] in Figure 6-2 .
1. Remove the two (2) flat-head socket
capscrews [ C
2
] connecting the cross brace
[ C
3
] to the back panel [ C
1
].
2. Remove the two (2) flat-head socket
capscrews [ C
5
] connecting the cross brace
[ C
6
] to the right side panel [ C
4
] at the front.
STEP 3 - UNFASTEN THE HOOD SPRINGS FROM
THE SIDE PANEL STUD MOUNTS
Refer to both insets [ D ] in Figure 6-2 .
1. Remove the mounting end caps [ D
1
& D
4
]
from the ends of the spring fasteners [ D
2
&
D
5
] by carefully prying them loose with a
screwdriver blade.
2. Pull the ends of the spring fasteners [ D
2
& D
5
]
from the mounting studs [ D
3
& D
6
].
STEP 5 - LOOSEN THE BACK AND RIGHT-SIDE
PANEL CONNECTION BOLTS
Refer to both insets [ E ] in Figure 6-2 . Note: The back
and right-side panels can remain attached to each other
for the removal process.
1. Loosen the three bolts [ E
1
] at the back left
corner, but do not remove; also loosen the
three bolts [
E
3
] at the front right corner, but
do not remove. Note: the bolts should be
loose enough to allow for the panel grooves
[
E
2
& E
4
] to slide away from the mounted
bolts as shown in the inset diagrams.