Vanair 050518, Руководство по эксплуатации и список запасных частей

Страница: 69 / 210

AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 5: OPERATION
090012-OP_r0 PAGE - 51
high idle and deliver the selected amperage
through the electrode. Now you may begin
to weld.
8. After a weld has been completed, and there is
no contact between the electrode and the metal
for 30 seconds, the engine will return to idle.
5.4.1.2 CV (CONSTANT VOLTAGE) MODE -
USING A VOLTAGE SENSING SUITCASE
FEEDER
CV (Constant Voltage) Mode – commonly referred to as -
Wire Welding, MIG welding, or Gas Metal Arc Welding
(GMAW)
1. With the engine shut off, insert the twist lock
connection of the ground clamp into the
negative (-) welder connection port on the
control panel. Insert the power lead segment
from the suitcase feeder into the positive (+)
welder connection port on the control panel.
2. Place the ground clamp from the suitcase
feeder and the ground clamp from the Air N
Arc 300 on the work piece.
3. Start the engine ( See Section 5.2, Engine
Start-up and Shutdown Procedure ).
4. On the control panel, place the DC Charger/
Welder switch in welder mode. Place the
CC/CV switch in CV mode.
5. Adjust the power dial on the Air N Arc 300 to
the appropriate voltage setting for the
material being welded. Adjust the power dial
on the suitcase feeder for the material being
welded. At anytime during welding, the
power dial may be adjusted to the desired
voltage level.
5.4.1.3 CV (CONSTANT VOLTAGE) MODE - USING
A SPOOL GUN
CV (Constant Voltage) Mode – commonly referred to as -
Wire Welding, MIG welding, or Gas Metal Arc Welding
(GMAW)
1. With the engine shut off, insert the twist lock
connection of the ground clamp into the
negative (-) welder connection port on the
control panel. Insert the power lead segment
from spool gun adapter into the positive (+)
welder connection port on the control panel.
NOTE
When using a spool gun, an adapter with
contactor must be used. Please consult
the spool gun manufacturer for
appropriate adapter.