Van Der Stahl LOS NT Series, Руководство по эксплуатации

Страница: 38 / 64

For 1500 model
1
The heating element is covered with fluoro glass
sheet. Loosen the white plastic nuts and free a
fluoro glass sheet roll bar. Flip the fluoro glass
sheet as per in the right illustration to uncover the
heating element.
2
Loosen the hollow screw using a hexagonal
wrench by turning it clockwise. The heating
element will be loosened.
3 Loosen the heating element securing screw with a
Philips screwdriver, and remove the heating
element.
4 Insert a new heating element terminal into the
electrode groove. Make sure that the heating
element stays in place with the electrode as you
securely tighten the heating element securing
screw. After tightening the screws, turn the
hollow screw counterclockwise using a
hexagonal wrench so the heating element
stretches out.
Reattach the fluoro glass sheet to the initial
position and fix it with the white plastic nuts.
Lower side
Upper side
LOS-NT/NTW series Operating Instructions Ver.6.02E
38
Caution
Always use a FUJIIMPULSE-
designated, special heating element
for replacement. Using a heating
element other than the designated
heating element may cause the
transformer to be heat-damaged.
Plastic nut (white)
Fluoro glass sheet roll bar
Hexagonal wrench(3mm) Hollow screw
Heating element
Phillips screwdriver
Heating element
securing screw
Hollow screw
Fluoro glass sheet
roll bar
Hexagonal
wrench(3mm)