Van Der Stahl LOS NT Series, Руководство по эксплуатации

Страница: 19 / 64

垂直
水平
シール角度の調整
左手で
シールヘッドを支え
ながら、
ハンド
ルを回して
角度調整して下さい。
Move the nozzle stroke adjustment collar located on the
upper part of the nozzle driving cylinder. Move it up or
down to adjust the nozzle stroke, how deep the nozzle
comes inside the pouch.
[Nozzle stroke: 0
~ 240mm]
Turn the adjuster knob on the right side of the machine
while supporting the sealer head with your hand. The
head will move to the vertical direction by turning it
clockwise, while turning counterclockwise will move to
the horizontal direction.
The sealing section can be variably
adjusted between 0 and 90 degrees
LOS-NT/NTW series Operating Instructions Ver.6.02E
19
7-8 Adjusting the sealing angle
7-9 Adjusting the nozzle position
Caution
Before adjustment, select the "SEALING
ONLY" mode to make the nozzle to be in the
back position.
Attention
To make the vacuuming operation easier,
sealing height, sealing angle, and nozzle
position are the important parameters.
These parameters are greatly affected by
the pouch size and packaging contents.
Make final adjustment as you actually
operate the machine and perform some
vacuuming tests.
Caution
Please do not move
"X5" (forward
confirmation) and "X4"
(backward
confirmation) sensor
switch since they are
fixed into place.
Nozzle stroke adjustment collar
Loosen the collar with the hexagonal
wrench (5mm) included in accessories
set.
Move the collar up or down to make the
proper adjustment and fasten the collar.