Van Der Stahl FEP-N2 Series, Руководство по эксплуатации

Страница: 31 / 38

FEP-N2 Series Operating Instructions Ver. 7.01E
FEP-N2
You can change print tape feed amount by switching
print line setting between one line or two lines with a
printing line selector switch.
At the time of factory shipment, two line printing mode
is selected. By changing the setting to one-line, print
tape feed amount is adjusted to about 5mm that is the
length used for printing one line.
When printing only in one line, use a 36mm spacer.
At the time of factory shipment, print tape feed amount
per one printing is as below:
Two-line printing mode … about 10mm
One-line printing mode … about 5mm
You can change this setting by turning an actuator pin
as in the right illustration.
After the adjustment, make sure to securely tighten the
nut using a spanner.
6ZLWFKSULQWOLQHVHWWLQJ
$GMXVWSULQWWDSHIHHGDPRXQW
Printing line selector switch
Actuator pin
Nut
Decrease tape feed amount
Turn clockwise to screw in
Turn counterclockwise to loosen
Increase tape feed amount
Caution
Set a 36mm-width spacer to a type
cassette case when not using a whole line
and printing only in one line.
Caution
The feed amount is adjusted to the
optimum condition at the factory before
shipping. Do not change this setting unless
the feed amount needs to be changed.
Caution
The actuator pin may come off if the nut is
loose. Securely tighten the nut every time
the adjustment is made using a spanner.