Vallox 096 MV, Руководство пользователя

Страница: 57 / 66

57
© Vallox • We reserve the right to make changes without prior notice
INSTALLATION
MOUNTING THE CEILING MOUNTING
PLATE
1. Attach the thread bars to the ceiling and turn the
nuts to the bars.
2. Lift the ceiling mounting plate in place.
3. Push a rubber damper and a washer to each
thread bar to the cup of the plate (096 MV).
4. Turn the nuts to make sure that the unit is
horizontally level.
5. Shorten the lower ends of the thread bars so that
they will be at no more than 10 mm from the
lower surface of the ceiling mounting plate.
WARNING
The ventilation unit is very heavy. Do not perform this
procedure alone.
MOUNTING THE VENTILATION UNIT TO
THE CEILING MOUNTING PLATE
1. Mount the locking washers (J) delivered with the
ceiling mounting plate in place with the 4 screws.
2. Lift the unit and take the wires through the opening
in the ceiling mounting plate.
3. Put the locking devices to the top of the ventilation
unit at the openings in the ceiling mounting plate
and lift upwards. Make sure that the unit is locked
in place.
4. Check that the condensing water insulation
between the unit and the ceiling mounting plate is
in place in the exhaust and outdoor air duct.
TIP
You can detach the unit from the ceiling mounting
plate by pulling the spring-loaded moulding to
the direction shown by the arrow (more detailed
information provided with the ceiling mounting plate).
ATTIC FLOOR PENETRATION PLATE
The attic floor penetration plate is optional. When an
attic floor penetration plate is used, the tightness of the
vapour barrier has to be ensured.
The minimum distance of the attic floor penetration
plate from the rear wall is 5 mm. The minimum
distance of the attic floor penetration plate from the
side walls is 15 mm.
096 MV - 544 mm
110 MV - 582 mm
096 MV - min. 4 mm
110 MV - min. 8 mm
096 MV - 332 mm
110 MV - 375 mm
096 MV - 600 mm
110 MV - 638 mm
max. 10 mm
INST
ALLA
TION
ATTIC FLOOR PENETRATION PLATE
CEILING MOUNTING
PLATE
096 MV
110 MV
4
X