Vallox 096 MV, Руководство пользователя

Страница: 39 / 66

39
© Vallox • We reserve the right to make changes without prior notice
MAINTENANCE INSTRUCTIONS
MAINTENANCE
To change the filters, proceed as follows:
1. Disconnect the ventilation unit from the mains electricity
supply.
2. Turn the latch to open the door of the Vallox ventilation unit.
3. Lift the door off.
4. Remove the old filters (A, B, C) and discard them.
5. Install the new filters (A, B, C).
6. Close the door of the unit. Ensure that the safety switch of the
door is engaged, allowing the unit to be turned on.
7. Plug the ventilation unit back into the mains.
8. The filters have now been successfully changed.
HEAT RECOVERY CELL
Check that the heat recovery cells are clean every two years, or
whenever the filters are being changed.
NOTE
If the unit has an enthalpy cell, it must not be washed. Only
aluminium or plastic cells can be washed.
To check the heat recovery cell, proceed as follows:
1. Disconnect the ventilation unit from the mains electricity
supply.
2. Open the Vallox ventilation unit door by turning the latch.
3. Lift the door off.
4. Remove the filters (A, B, C).
5. Remove the sealing strip (E) above the cell in the direction of
the arrow.
6. Lift and pull the cell (D) out of the unit.
7. If the cell is dirty, clean it by immersing it in warm water, to
which a small amount of a mild detergent has been added.
8. Rinse the cell clean with a water spray. Do not use a high-
pressure cleaner.
9. When all the water has drained from between the layers,
reassemble the ventilation unit in the reverse order.
10. When reassembling model 096 MV, check that the sealing
strip below the cell is pressed against the bottom of the unit.
11. Close the door and plug the unit back into the mains.
12. The heat recovery cell has now been checked and cleaned.
WARNING
Handle the cell carefully! Do not lift
the cells by the layers, as the cell
layers are very fragile.