Vaisala Veriteq vNet PoE Device, Руководство пользователя, Страница: 10 / 37

6 © 2010 Veriteq Instruments Inc.
9
From the Scenario List, select RealPort (COM Port
Redirection) , then click Next .
10
Ensure the Install Digi RealPort on this computer
checkbox is checked, click Next , then click Next on the
following screen. Wait for the new settings to be saved to
the device. This will take up to 3 minutes, depending on
the device.
11
If you have another device to install, check the
Configure another device checkbox, then click Finish .
Repeat steps 5 through 11.
12
When the last device has been installed, clear the
Configure another device checkbox, then click Finish .
13
A list of all installed devices that use the RealPort driver
will be displayed in the Command Prompt window after a
short delay. Record the COM port number(s) of the
device(s) you installed, as you will need to know them
when using the Veriteq software products. Close the
Command Prompt window by selecting the title bar, then
pressing any key on the keyboard.
14
Refer to the Launching the vNet Configuration and
Management Interface section for further instructions
on opening the web-based interface to change the
password or other settings.
Installing Drivers Using RealPort Setup
Device drivers must be installed in Windows
®
for each of the
vNet or Digi devices that are connected to the network. This
allows the Veriteq software to access the data loggers.
Use the instructions in this section if the drivers will be
installed on a PC that is on a
different subnet than the vNet or
Digi devices. If the PC is on the same subnet, use the
Installing Drivers Using Device Setup section instead.
1
Obtain an IP address for each of the vNet or Digi devices
from your IT department. They should either be reserved
IP addresses supplied by DHCP or static IP addresses. If
the IP addresses are being reserved, the DHCP server
must be updated
before you proceed with the installation.