Vaisala DMP248, Руководство по эксплуатации

Страница: 93 / 141

A
PPENDIX
1
SERIAL COMMANDS
__________________________________________________________
V
AISALA
_________________________________________________________________________ 89
ERRS Outputting error messages
ERRS <cr>
During operation error messages are not output automatically through the se-
rial interface. If there is any reason to doubt that there is something wrong with
the transmitter, possible error messages can be output with command ERRS.
If there are no error messages, only a prompt is displayed:
>ERRS <cr>
>
If errors have occurred, the transmitter outputs the error code (see Appendix 5
for error messages):
>ERRS <cr>
E40 f ( all ) out of range
>
ECHO Turning the serial interface echo ON/OFF
ECHO xxx <cr>
xxx = ON or OFF
When the echo is off, the commands given through the serial interface or the
prompt > cannot be seen on the display.
When the serial interface is in half-duplex mode, the echo is always off. Even
then the ECHO command can indicate that echo is on.
INTV Setting the output interval for the RUN state
INTV xxx yyy <cr>
xxx = output interval (0...255)
0: no pause between outputs
yyy = unit (s, min or h)
Sets the output interval when the transmitter outputs
measurement readings to a peripheral device.
For example, the currently valid settings are output with:
>INTV <cr>
Output intrv. : 0 min
All manuals and user guides at all-guides.com