Installation manual auroTHERM 0020100606_02
22
1
2
3
5
4
Fig. 5.11 Fitting a further front section (here, a right hand or centre front
section)
>
Have the centre (or right hand) front sec-
tion (
¬ Table 5.1/5.3, Item 34
) of the
frame ready.
>
Bend the flexible apron of the previously
fitted front section down by approx. 3 cm
on its right hand side (
1
).
>
Lift the upper protective film on the bent
flexible apron at the top as far as the
bend (
1
).
>
Stick the right hand sheet to the bent over
apron of the left hand sheet (
1
).
>
Take care that the edge of the sheet and
the apron close flush with one another.
>
Push the slot on the left hand sheet into
the fold on the right hand sheet (
2
) and
(
3
).
>
Align the right hand sheet to the mark on
the left hand sheet (
4
).
>
Now remove the entire
upper
protective
film from the adhesive surface on the left
hand sheet.
>
Then press once more on the right hand
sheet.
>
Screw the sheet to the roof batten (
5
)
with 6 No.
1
screws (
¬ Table 5.2/5.4
)
using the Torx bit.
s
Only for the vertical collector position
>
Continue with the assembly of the vertical collector
rows after fitting a front section for each one. The
remaining front sections are fitted when starting each
additional vertical row.
w
Only for the horizontal collector position
>
Continue with the assembly of the vertical collector
rows after fitting two front sections for each row. Fur-
ther front sections are fitted when starting each addi-
tional vertical row.
5 Assembly
Содержание auroTHERM VFK 145/2 H
Страница 43: ......
