Installation manual auroTHERM 0020100606_02
34
1
max 150
1066
1066
4
3
2
Fig. 5.32 Fitting lower ridge plate couplings (horizontal collector)
w
With horizontal collector position
>
Attach the lower ridge plate couplings
(
¬ Table 5.1/5.3, Item 16
) above the
collector:
– one on the external edge
(max. 150 mm from the edge).
– in the centre of the collector
(1066 mm from the edge).
– one per collector joint (central).
>
Make sure that the lower ridge plate cou-
plings are resting on the collector frame
slot (
1
).
>
Slide a support board (
¬ Table 5.3,
Item 18
) through the straps on the lower
ridge plate coupling (
2
).
>
Join the lower ridge plate couplings to the
support board with two No.
2
screws each
(
¬ Table 5.2/5.4
) using the Torx bit to
prevent it from slipping (
3
).
>
Screw the lower ridge plate coupling at the
top to the roof batten (
4
).
2
1
Fig. 5.33 Mounting the ridge plates
>
Remove the protective film from the ridge
plates (
¬ Table 5.1/5.3, Item 14, 15, 10
).
>
Slide the ridge plates (
1
) over the lower
ridge plate couplings.
>
Make sure that the ridge plates are above
the side sections and slip into the corre-
sponding rail (
2
).
>
Start with a left hand ridge plate
(
¬ Table 5.1/5.3, Item 14
).
>
If there are three or more collectors next
to one another, fit the corresponding
number of centre ridge plates
(
¬ Table 5.1/5.3, Item 10
) an.
>
To finish, fit the right hand ridge plate
(
¬ Table 5.1/5.3, Item 15
).
2
1
1
3
4
Fig. 5.34 Screwing down the ridge plates and attaching the upper ridge
plate couplings
>
Fasten all the ridge plates to the roof
battens with the No.
1
screws
(
¬ Table 5.2/5.4
) using the Torx bit (
1
).
>
Take the required number of upper ridge
plate couplers (
¬ Table 5.1/5.3, Item 11
).
An upper ridge plate coupling must be
screwed between each left hand, centre
and right hand ridge plate.
>
Fasten all the upper ridge plate couplings
(
2
) above the ridge plate joint with two
No.
4
screws
(¬ Table 5.2/5.4), Item (3)
in Fig. 5.34, and one No. 1 screw
(¬ Table 5.2/5.4), Item (4) in Fig. 5.34
,
using the Torx bit.
5 Assembly
Содержание auroTHERM VFK 145/2 H
Страница 43: ......
