5
01.03.2017
ST 600-900S
3. Set SystemDisc
• It is important to vent all hydraulic cylinders prior to making any adjustment. Refer to the manual
menu on page 10.
• In order to set the centre and wing sections, lower the front tool to approx. 1 cm above the ground.
• Adjust the piston rods of the wing front tool if this is necessary in order to have the wings at centre
level.
Short piston rod
Extend the piston
rod
Front tool System Disc
If the front and rear discs have different distances to the ground, adjust the push rods (
A
) in order to bring
the front and rear discs to the same distance to the ground.
A
Adjust the length of the piston rods (
B
) if
the CrossBoard does not line up between
the centre and wing sections.
B
Front tool System Disc and CrossBoard Heavy
Settings
