7
01.03.2017
ST 600-900S
Settings
5. Spill prevention plates
The relationship between SystemDisc
and the spill prevent plates can be ad-
justed. This does not normally need to
be done.
4. Front tool Single CrossBoard Heavy
• It is important to vent all hydraulic cylinders
prior to making any adjustment.
• In order to set the centre and wing sections,
lower the front tool to approx. 1 cm above the
ground.
• Adjust the piston rods of the wing front tool if
this is necessary in order to have the wings at
centre level.
• The work angle of CrossBoard is set using the
turnbuckles (A).
A
6. Linear seed drill unit
• NOTE:
Ensure that both of the bout marker arms are deactivated before this operation!!!
• Lift the seed coulters to the top position and here place 3 thick and 3 thin clips on the clips holder axle.
• Ensure that the nut and thread are 35 mm at the centre section (refer to image below).
• Start the fan (to obtain coulter pressure).
• Lower using the Yellow circuit.
• Compare the wing sections with the centre section.
• If adjustment is required, raise the seed coulter in order to relieve the load on the adjustment nut.
35 mm
Tighten the
nut
Untighten the
nut
