UTIFORM Convey 260, Инструкция по эксплуатации, Страница: 30 / 85

Electric Soladora CONVEY 260
www.utiform.com departamento.técnico@utiform.com Tfno. + 34 96 570 29 82 fax: + 34 96 570 29 83
29
To place the exit recipient in a place where it can leave the dirty water without causing any type of
damage.
To close the cover of the deposit, to start the machine and to transport the dirty water for the hoses of
transport and the receiver material exit toward out.
To hold the receiving tripod of material exit well because they leave mortar remains, he/she dilutes to
wash and air of transport low pressure.
To clarify the deposit of blended a second time, to fill it until the half with water and to empty it again,
as previously described.
For the final cleaning in the hoses of transport to use the rubber balls (ref. 3500180) introducing
them in their interior to eliminate the mortar remains that can be deposited in their interior.
To repeat this process the necessary times until the water that comes out for final end of the
hoses is totally clean.
7.11 Shortcomings in the transport
The mixture material is not transported
If the material is not transported at one time by the hose of transport very brief, there is a mishap.
•
To close the faucets for the superior and inferior air. This way, it is avoided that the compressed air
escapes unsuccessfully for the hose of transport it empties.
•
To disconnect the machine and to assure it against an unauthorized connection.
•
To eliminate the causes, for example the inadequate constitution of the mixture ingredients.
A plug in the hose of transport
When there is a plug in the hose of transport the manometer of the mixture deposit it ascends to a
pressure from 7 to 8 bar, since it cannot leave the compressed air.
Not to open the cover of the deposit! The deposit and the hoses support a pressure of higher break to it
specifies it previously, for what doesn't constitute any source of danger.
1.
To check where he/she is the plug, hitting the hose of transport
2.
When he/she has been the plug, to move the tube from a side to another strongly.
In most of the cases, this process is enough so that the plug disappears. If the movement was not
enough:
To disconnect the air transporters!
3. To close the faucets for the inferior air and superior and to open the mixture deposit.
To take protection glasses!
To keep in mind, although the machine is stopped that the hoses of transport are low pressure, for what
the mortar remains could cause lesions when opening the working of the hose.
Care with material splashes! To take protection clothes!
4.
To wait until the manometer of the deposit indicates 0 bar.
5.
To only open then the hose of transport in the corked part and to eliminate the plug.