UTIFORM Convey 260, Инструкция по эксплуатации, Страница: 18 / 85

Electric Soladora CONVEY 260
www.utiform.com departamento.técnico@utiform.com Tfno. + 34 96 570 29 82 fax: + 34 96 570 29 83
17
6 Preparation for the operation
6.1
Safe-deposit indications
•
The sure work and carefully it begins with the election of the place of installation of the machine. In the
working place it is necessary to familiarize first with the working environment.
•
The installation of the machine should be in a fixed place and plane.
•
If the machine is equipped with load chute, in the place where it is placed he/she has to have enough space so
that it can lower the same one without difficulty.
•
In the event of machine with load chute is necessary to put the machine at level being helped of the support
paws that are located to both sides of the boiler of blended, assuring them with their corresponding pins.
•
In a place with powder is to keep in mind that the powder doesn't blow in the address of the system of
aspiration of air. The air filter gets dirty quite quicker and the maintenance intervals, also for the refrigerator,
they shorten considerably.
•
Not to place the machine in places where an explosion can take place. Unless it is a machine that is
technically as amended for it. To pay special attention to the indications on the electric motors and of gas oil.
•
To place the machine in such a way that the working place is protected by objects with easy fall on the same
one or the personnel that it surrounds it. To take helmet protective ATTENTION!
•
To assure the machine so that it cannot move with the parking control and chucks dedicated for this end. It is
advisable to remove the system of illumination of the machine and to keep it in sure place.
•
To work the machine with the necessary safety appliances.
•
To connect the machine with the cables of the current.
•
To place the tubes of transport tracing a road the shortest thing possible. To calculate for the changes of
address generous radios (I radiate of curve = six times the external diameter of the tubes), avoiding that the
hoses of transport bend. As much as less joinings have better, since this way the fuljo free of the material is
facilitated by the interior of the tubes transporters.
•
To tie the ascent lines very carefully with the fixers of the foreseen tube, so that they don't break for their
own weight. We recommend our hooks for the hoses of cloth transport or leather.
•
To assure all the connections of the joinings in the connected tubes to avoid that they can open up.
•
To control the tubes and joinings regularly against waste (abrasion and aging, see you the leaf of safe-deposit
control for a good state).
For the security in the operation is indispensable that tubes transporters and original joinings of
UTIFORM are only used (or authorized by the maker).