ZenCut Black User Manua
l
Then turn the roll downward to make an equal tension across the media
(See Figure 4-15)
4.
Engage pinch rollers.
Figure 4-15
Make sure that the media
tension is equally distributed
from left to right. If the media
is not taut enough against the
platen, it will cause tracking
problems.
5.
Adjust roll media guide bushes on the roll holder to secure the roll media.
6.
The protrusion length of the blade should be longer than the thickness of the vinyl.
(Please check the “Blade Specification: About the Tool” in Appendix.) Once all of the
above settings are correct, you’re ready to cut for large signs.
4.6 When Completing the Cutting Job
After completing the cutting job, raise the sheet-loading lever, and then remove the material.
You can also cut off the finished job using the Safe Blade (a standard accessory) along the knife
guide. (Figure 4-16)
Operation
4-8
Figure 4-16
