ZenCut Black User Manua
l
Chapter 4 Operation
4.1 Media Loading
4.1.1 Loading the Sheet Media
To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or lower down pinch rollers.
Pull the lever forward until it makes a clicking sound then the pinch rollers are raised (
Figure
4-1
).
Step 2
Load your media on the platen and slide it under the pinch rollers from either the front side or
the backside. The
alignment rulers
on the platen extension will help you to adjust the media
precisely.
Note:
When loading the media, be
sure that the media must be
covered by the paper sensors on
the platen. At least one of the
two paper sensors (Figure 4-2)
should be covered. Once the
media covers the sensor, the
cutting plotter will size the media
width and length automatically.
Paper sensors
Figure 4-2
Figure 4-1
Lever
Operation
4-1
