2
Installation, Operation and Maintenance Manual
FSF-200-OG, FSF-250-OG, FSF-300-OG,
FSF-500-OG
Table of Contents
Unpacking/Inspection ................................................................................... 2
Safety Guide………………………………………………………………………..2
Proper Installation………………………………………………………………….3
Introduction…………………………………………………………………………3
Component Checklists…………………………………………………………….4
System Overview and Specifications………………………………………….…5
How The Fusion Oxi-Gen Treatment System Works…………………….….…6
Fusion Installation Instructions and Specifications…..……………………..…7
Tank and Control Valve Preparation…………………………………..…….….7
Injection Panel Installation Instructions………………………………….……...9
Carbon Tank Installation Instructions...………………..…...………………....13
Injection Panel Chemical Solution Tank Installation Instructions…………....15
Chemical Injection Panel Start-up Instructions……………………….………..17
Control Valve Keypad Functions …………………………….…………......…..18
Control Valve Programming……………………………………………..…….…19
System Start-up Instructions……………………………………………………..20
H2O2 Injection Rate Adjustment Instructions (Bubble Method)………..........21
What To Expect and Routine Maintenance……………………………............22
Maintenance Schedule……………………………………………………...........23
Limited Lifetime Warranty………………………………………………..…….…24
Safety Guide
Be sure to check the entire system for any shipping damage or parts loss. Also note damage to the shipping
cartons. Contact US Water Systems at 1-800-608-8792 to report any shipping damage within 24 hours of de-
livery. Claims made after 24 hours may not be honored.
Small parts needed to install the system are in a parts bag. To avoid loss of the small parts, keep them in the
parts bag until they are used.
Unpacking / Inspection
Check and comply with provincial / state and local
codes and follow these guidelines.
Use care when handling the iron removal system.
Do not turn upside down, drop, drag or set on
sharp protrusions.
The backwashing carbon filter uses 12 volt-60 Hz
electrical power only. Be sure to use only the in-
cluded transformer.
Transformer must be plugged into an indoor 120
volt, grounded outlet only.
WARNING
: This system is not intended for
treating water that is microbiologically unsafe or of
unknown quality without adequate disinfection be-
fore or after the system. Contact US Water Sys-
tems for disinfection treatment equipment.
