16
3. Be sure the weighted strainer on the 1/4” tubing until it can be seen in the slots in the
weighted strainer. Then drop the strainer in the tank and push the 1/4” tubing through the
hole in the tank until the weighted strainer is about 1” off the bottom of the tank.
4. Now attach the other end of the 1/4” tubing to the pump on the injection panel. Put the nut
over the tubing and then the sleeve. Push the tubing in the pump fitting and tighten the nut
hand tight. The connection on the pump should be held with one hand while the nut is tight-
ened with the other hand. Hand tight should be sufficient.
Injection Panel Chemical Solution Tank Installation Instructions
Installation, Operation and Maintenance Manual
FSF-200-OG, FSF-250-OG, FSF-300-OG,
FSF-500-OG
