12
b
uRneR
a
ssembLy
R
emovaL
:
1. Remove the safety screen (see
M
aIntenance
anD
s
erVIce
- s
afety
s
creen
r
eMoVal
on page 10).
2. Remove the door trim (see
M
aIntenance
anD
s
erVIce
- D
oor
t
rIM
r
eMoVal
on page 11
).
3. Remove the glass door (see
M
aIntenance
anD
s
erVIce
- G
lass
D
oor
r
eMoVal
on page 11)
4. Remove log set (if installed).
Maintenance And Service
5. Remove the Log Grate by removing the two (2)
T-20 screws at the rear of the grate and loosening
the two screws holding the log grate clamps in
place near the front of the grate (see Figure 8).
6. Remove the two (2) T-20 screws securing the
orifice mount clamp onto the burner (see Figure
9).
7. Remove the two (2) T-20 screws securing the
pilot assembly to the burner.
8. Loosen the four (4) T-20 screws securing the
burner to the firebox (see Figure 10). The
burner has keyslot holes that allow the burner
to then be removed without fully removing the
screws.
To re-install the burners, follow the steps above
in reverse. When placing the burners back in the
unit, be sure not to move the air shutter. Do not
over tighten the burner screws or they might
strip; just get them snug.
Figure 8: Log Grate Removal
The burner will need to be removed for maintenance and fuel conversion. Follow the procedure carefully.
Proceed only when the unit has completely cooled down.
Figure 9:
Orifice Mount Clamp
Figure 10: Log Burner Removal
T20 Screws
(x4)
