Upright ab62, Руководство по обслуживанию и запасным частям

Страница: 11 / 146

AB62 Work Platform - European 2-1
S e c t i o n 2
M
ACHINE
P
REPARATION
& O
PERATION
Use of the aerial work platform: This aerial work platform is intended to lift persons and his tools as well as the material used for
the job. It is designed for repair and assembly jobs and assignments at overhead workplaces (ceilings, cranes, roof structures, build-
ings etc.). All other uses of the aerial work platform are prohibited!
This aerial work platform is not insulated! For this reason it is imperative to keep a safe distance from live parts of electrical
equipment!
All occupants must wear an approved fall restraint properly attached to designated platform anchorage point. Attach only one fall
restraint to each anchorage point.
E xceeding the specified permissible maximum load of 225 kg (500 lbs) or two persons on the platform is prohibited!
The use and operation of the aerial work platform as a lifting tool or a crane (lifting of loads from below upwards or from up high on
down) is prohibited!
Never exceed 200 N (45 lbs) of side force per occupant.
Distribute all platform loads evenly on the platform.
Never operate the machine without first surveying the work area for surface hazards such as holes, drop-offs, bumps, curbs, or
debris; and avoiding them.
Operate the machine only on surfaces capable of supporting wheel loads.
Never operate the machine when wind speeds exceed 45 km/h (28 mph) (12,5 m/sec.= Beaufort scale 6).
In case of emergency push emergency stop button to cut power to all machine functions.
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel or prefab concrete structures,
etc., is prohibited.
Dismantling the swing gate or the liftable bar or other railing components is prohibited! Always make certain that the swing gate or
the liftable bar is closed and securely locked! It is prohibited to keep the swing gate or the liftable bar in an open position (e.g. held
open with tie-straps) when the platform is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform is prohibited!
Inspect the machine thoroughly for cracked welds, loose or missing hardware, hydraulics, loose wire connections, and damaged
cables or hoses before using.
Verify that all labels are in place and legible before using.
Never use a machine that is damaged, not functioning properly, or has damaged or missing labels.
If Alarm Sounds while boom is elevated, STOP, carefully retract boom and lower the platform without rotating. Move the machine to
a firm, level service.
To bypass any safety equipment is prohibited and presents a danger for the persons on the aerial work platform and in its working
range.
Never charge battery near sparks or open flame. Charging batteries emit explosive hydrogen gas.
Modifications to the aerial work platform are prohibited or permissible only at the approval by UpRight.
Never tow the machine. Transport by truck or trailer only.
After use, secure the work platform from unauthorized use by turning both keyswitches off and removing all keys.
Warning
All personnel shall carefully read, understand and follow all safety rules and operating instructions before operating or
performing maintenance on any UpRight aerial work platform.
S a f e t y R u l e s
Electrocution Hazard Tip Over Hazard
Collision Hazard Fall Hazard
NEVER operate the boom or
drive with the platform ele-
vated unless on firm, level
surface. NEVER position the plat-
form without first checking
for overhead obstructions
or other hazards .
NEVER climb, stand or
sit on the platform guard-
rails or midrail.
THIS MACHINE IS
NOT INSULATED