Page 27
X100 SERIES
INSTALLATION & OPERATING MANUAL
Manual No. x100-5a
x100-man-Rev5a-0214.indd
12.3
Controller Factory Calibration
The primary purpose of the
Controller Factory Calibration
page is to allow
UNIPOWER to setup a range of necessary calibration values to ensure correct
operation.
When this page is requested and the Java applet has loaded a dialog requesting the
Level 2 Pass code is presented. Once the pass code has been entered click
ENTER
and the page will then be updated with current values after a few seconds.
Figure 7 - Controller Factory Calibration WEB Page (typical)
NOTE: It should not normally be necessary for changes to be made to this page other
than to change the pass codes if so desired.
The factory default pass codes are:
Pass code Level 1 – 111
Pass code Level 2 – 123
