UniPOS IFS7002R, Инструкция по эксплуатации

Страница: 14 / 62

UniPOS Repeater IFS7002R
Instruction Manual Page 14
Revision 2/16.11.09 Of 62
Press it twice to suppress the
activated local sounders of the
connected fire control panels. Fire condition.
Button is active again when
registering new fire or fault in
connected fire control panels.
„Fire
Condition
stage II”
All Press the button to force transition
from phase Fire condition stage I to
phase Fire condition stage II. The button act once.
The button is removed after
activation.
,
“Outputs”
2, 3 and
4
Suppress/enable activation of the
outputs for Fire condition.
Password is required for Level 2
(item 5.4.2)
•
Where activated outputs for Fire
condition are available – these
outputs will be suppressed.
•
Where activated outputs for Fire
condition are not available – the
suppressed outputs will be
activated.
Addressable outputs, activated
by the inputs, can not be
suppressed.
The buttons have opposite
function (suppressing/enabling)
and in this aspect only one of
them is always shown on the
display.
Suppressed outputs for Fire
condition are triggered when:
- entering in Fire condition in a
new zone;
- transition from Fire condition
stage I to Fire condition stage II.
If the panel is in “Information and
Control Mode” and meanwhile
there is a fire event, the button
will display the information
for the fire event.
“Reset
Fire”
2, 3 and
4
Reset the remote fire control panel. Acts on is indicated in the box
above the display “Fire”.
Resetting the fire is made in
connected panels and zones.
The repeater remains in Fire
condition until all Fire conditions
in each of the fire control panels
connected with it is reset.
and
“Move Down”
and
“Move Up”
All Use buttons to select the fire control
panel that will exit the Fire condition.
Show repressed messages in fire
zones.
Visualization is a field of characters
for the first window > on the LCD.
Show messages suppressed for
devices in a fire. Visualization is in
the first two fields of the second
window on the LCD. Buttons are active only in the
presence of suppressed
messages, ie:
- Serial number of the fires are
not consistent;
- Serial numbers of devices in the
fire were not consistent.
“Menu”
2, 3 and
4
Press the button to enter
Information and Control mode. The
mode uses the second and the third
panel of the screen for Fire
condition.
“Exit”
2, 3 and
4
When Fire condition is in
combination with Information and
Control mode, press the button and