UniPOS
Interactive Fire ControlPanel IFS7002
Instruction Manual
Page
17
Revision 2.05
Of 107
8.2.2. Text messages
Information on zones for which
the fire control panel has detected
Fire condition is displayed:
For this condition the display is
divided into three panels.
The first panel (the upper one)
displays information on zones in fire
condition. A flashing heading with the
text FIRE and the total number of
zones in fire condition appear. The
panel is subdivided into two text
fields, each providing two lines. The
first line displays information on the
first zone in fire condition, the second
line provides information on the last
zone in fire condition.
The first line of each field provides information on the type of the fire condition:
−
the sequence number of the indicated fire condition;
−
the phase of Fire condition detected by the fire control panel in this particular zone;
−
the zone number;
−
the remaining time in seconds before the fire control panel proceeds to phase
Fire condition
stage II
(indicated only in
Fire condition stage I
).
The second line of each field displays a text message for the corresponding zone. If the fire
control panel has entered Fire condition in more than two zones, the rest of the text messages for fire
condition are suppressed. They can be displayed in the upper field by pressing the buttons on the
right side (see section 8.3.5.1).
The second panel (the middle one) provides information on devices in fire condition. In the head
part is displayed the total number of devices in fire condition. The panel itself is subdivided into three
text fields, each providing two lines. The upper two-line field displays information on the first device
that has detected fire condition; the middle two-line field displays information on the second device in
fire condition, the bottom two-line field – information on the last device.
The first line of each field provides information on the device:
−
the sequence number of the device in fire condition;
−
the fire alarm loop where the device is integrated into;
−
the zone number;
−
the device address in the fire alarm loop.
The second line of each field displays text messages relevant to this particular device.
If more than three devices are activated due to fire condition, the rest of the messages are
suppressed. However, they can be displayed in the upper fields, by pressing the buttons on the right
side (see section 8.3.5.2).
The third panel (the bottom one) displays information on the numbers of faults and disables –
total number and for the outputs (monitored outputs and addressable output devices).
8.3. Using the keypad
8.3.1. Button
(Inspection)
The button appears on the display when the fire control panel enters phase
Fire condition stage I
in a new zone; it is extinguished if pressed or if all zones in Fire condition proceed to phase
Fire
condition stage II
.
When you press the Inspection button, the remaining time for the zones in
Fire condition stage I
after which they proceed to
Fire condition stage II
, is prolonged with user programmed inspection time
for each particular zone. The operation can be performed only once for each zone in
Fire condition
Mode:DAY
11:11:08
Thu 03 Feb 2005
FIRE CONDITION
ZONES IN FIRE:
3
1 Phase 2 Zone 001
Zone 001
3 Phase 1 Zone 002
Zone 002
Time Fire Phase2: 120
Devices in Fire
TOTAL NUMBER:
4
1 Loop 01 Zone 001 Addr 001
Point 1.001
2 Loop 02 Zone 003 Addr 001
Point 2.001
4 Loop 01 Zone 002 Addr 002
Point 1.002
Faults Total: 00000
Disables Total: 000
Failed Outputs: 00000
Disabled Outputs: 000
