Uninet iColor LF700, Руководство пользователя

Страница: 77 / 82

iColor LF700 Manual Version 3.6
Uninet Copyright 2014
Page 77
The Registration Of The Cut Labels Is Out.
The registration at the bottom of the page is good but gets worse towards the top. This will more noticeable
on the smaller labels.
This could be print scale issue, if the amount of shift is the same from page to page then run the ‘Feed Scale
Calibration Print’ on the printer.
Check that the OPOS sensor is mounted correctly and that only up and down movement can be made.
Clearly printed reg marks are vital.
‘Media CAL’ value. If this is to low then the OPOS sensor may be triggering slightly inconsistently. Change
the Media CAL value. Recalibrate the OPOS
Try printing a 200mm squire and measure it precisely on both the X,Y axis and also across the diagonal. If
the two diagonal values are different then there is skew in the print.
A Contaminated or faulty OPOS sensor could also to be to blame. , clean the sensor first and re-test.
Using the LF700 to Cut Blank Labels.
It is important to note that
LF700
machines have only had the ability to cut blanks from November 2013,
your machine might not have this function included.
The first step is to produce the cut profile in ether Illustrator or Corel Draw, this is done in the same way as
for printed media but without the need of any print data or the printed reg mark.
1. Just create your cut profiles, add the OPOS marks using the plug-in and output to WinPlot.
2. Load the
LF700
with plain media.
3. Press the ‘Menu’ button, scroll through until you find the new option ‘Page Size’ enter the total height of
the labels in the x-axis plus the label gaps. e.g.. if you label is 95mm high with a 3mm label gap and there
are 3 up the page then the value to be entered is 294mm.
4. Place the cutter tool inside the edge of the media (this is approximately the same place as the printed reg
mark would be).
5. From WinPlot highlight one of the cut profiles and click on the button to the left of the ‘Send to OPOS’
button called ‘Send design to Cutter’.
6. From the dialogue box select ‘ Colour in Selection’.
The
LF700
will then cut the selected profiles and use the ‘page size’ value you entered to repeat the cut.
It is important that is you want to cut a set number of repeats then this quantity must be sent in page count
before the job is started.