Identification label and additional or replacement parts of the Linear Unit
1 -
ID number
2 -
Serial number
3 -
Type of Linear Unit (ordering code)
In the case of ordering additional or
replacement parts for the Linear Unit
there must be given all data from the
identification label.
MOUNTING
Fixing system
The Linear Unit must be mounted by
the aluminium profile with evenly
distributed clamping fixtures along
the entire length!
www.unimotion.eu
MTV Series
MANUAL
1.030.0
O
VERVIEW
The modules are mounted by
using fixtures which are placed
in the slot on the side of the
profile.
A
[ mm ]
B
[ mm ]
MTV
Number of clamping fixtures
Please refer to our catalogue UNIMOTION
Linear Units on page 7.000.0
65
78
93
Linear Units
Linear Units
Linear Units
Linear Units
Linear Units
±0,1
80
93
108
Fixing system - TAP/PIN Holes
Fixing the Linear Unit can also be done by the botom of profile using TAP / PIN holes, which can be made on request.
TAP / PIN holes can only be made based on the manufacturer’s drawing of the position and depth of
the TAP / PIN holes. For the drawings showing position and depth of TAP/PIN holes, please contact us.
The label
must be
fully
visible
(in particular details of the serial
number) and must ensure compliance with
all
the
instructions contained on
i
t
. Damaged or illegible label
s
must be replaced.
The specifications in order to improve the products in this catalogue are subject to change without notice.
