1.065.0
MTV Series
MANUAL
Ball Nut
type
Ball screw
Grease - relubrication quantiy
[ cm ]
[ d × I ]
MTV 65
16 × 5
1
.
4
RSY
16 × 10
1.6
16 × 16
1.8
Travel path
250
500
800
[ km ]
3
Ball nut
Carriage
[ cm ]
2
.
6
2.6
2.6
3
Lubrication of the ball nut and the carriage
Ball nut and carriage lubrication is done via
lubricating nipple DIN 3405 D at the center of the
carriage.
Lubrication of the cover strip
Apply a thin oil film to the cover strip.
To ensure that the oil is applied equally on the cover
strip move the carriage up and down the profile.
Please note that, if the linear unit is working in an
area with many dust particles, the lubrication must be
reapplied every once in a while.
For each Linear Unit the basic lubrication is done in the factory before shipment.
All bearings have been lubricated for life and do not require any additional lubrication under normal operating
conditions.
Recommended oil for steel cover strip
Lubcon TURMOFLUID ED 13
Lubricant
Recommended grease for the lubrication
Lubcon TURMOGREASE LC 802 EP
For lubrication and re-lubrication of linear units grease lubricant must only be used!
Do not use the grease which contains any solid parts!
The stated lubrication intervals in the table
are sufficient for normal operating conditions.
If you have special operating systems please
contact us.
The lubrication intervals are every 500
operating hours or after the specified travel
path stated in the table is reached. It
dependson which value is reached first.
Normal operating conditions
Temperature:
Travel speed:
Load:
10 °C - 30 °C
=
1 m/s
Ball screw speed (RPM):
2500 1/min
Stroke:
MTV 65 > 60 mm
MTV 80 > 60 mm
=
0.2
C
MAINTENANCE
Lubricant quantities and intervals
MTV 80
20
× 5
2
RSY
20 × 10
2.5
20 × 20
3
250
500
1000
3
3.5
4
The specifications in order to improve the products in this catalogue are subject to change without notice.
