Unical STILE 27, Инструкция по установке, техническому обслуживанию и эксплуатации

Страница: 16 / 60

16
Installation instructions
3.3 - PACKAGING
The STILE 27 heat stove is delivered encased on a pallet
and protected by cardboard packaging.
After having removed packaging, make sure that
the supply is complete and undamaged.
If in doubt, do not use the appliance and contact
the supplier.
To handle the heat stove and to remove the pallet
below, remove the top and, using appropriate
lifting systems, fasten the upper hook intended
for this purpose.
Keep the packaging material (cardboard boxes,
straps, plastic bags, etc.) out of the reach of
children as they are potential sources of
danger .
Unical will not be held liable for damage to persons, animals
or objects due to failure to comply with the above instruction.
The document envelope, inserted in the combustion chamber,
contains:
- Heating system booklet
- The installation, maintenance and operating instruction
booklet
- Warranty
- Local ventilation requirements adhesive label
If the heat stove is stored for long periods, it should be
adequately protected.
3.4 - INSTALLATION
STILE 27 is a heat generator which withdraws the combustion
air required for the combustion process directly from the
environment in which it is installed.
For this reason, and above all for the safety of the persons
using STILE 27, it must be installed in a sufficiently ventilated
area so that a continuous flow of combustion air is guaranteed.
It is therefore essential to make air vents linked with the outside
which, in compliance with that indicated by Standard UNI
10683, have the following features:
1. Have a free cross-section no less than 80 cm
2
;
2. Be made close to the floor;
3. Be appropriately protected by metallic mesh or grille so
that the minimum air passage cross-section is not reduced;
4. Be positioned in such a way that it cannot be obstructed.
The correct air influx can also be guaranteed
by using openings towards an adjacent
room as long as that room is provided with
direct ventilation and it has no fire risks such
as depots, garages or storerooms as
regulated by standard UNI 10683.
STILE 27 should be installed in rooms without appliances
which do not operate in an airtight fashion respect to the room
or appliances which can create a vacuum in the room respect
to the outside environment and therefore hinder the draught
of the flue gas exhaust system (UNI 10683).
To make it easier to clean, there must be a clearance space in
front of the heat stove no less than the length of the stove itself.
You must at least make sure that the door can open 90°
unobstructed
The heat stove can be placed directly on the floor as it is
equipped with a self-supporting frame.
When inspecting compatibility of the heating system, you
should make sure that the support surface (floor) has a support
capacity (kg) suitable to bear the weight of the product. If it is
not adequate, suitable safety measures should be taken (e.g.
load distribution plate).
Furthermore, should the floor be made of combustible material
(such as parquet) it should be protected by using a sheet of
fireproof material underneath STILE 27 sufficiently wider than
the base.
When installation has been performed, the heat stove must
be horizontal and stable, in order to reduce vibrations and
noise.
However clearance space must be left behind the heat stove
and on both sides to allow the casing to be opened to service
the fan and the pellet feeding screw.
During installation, place the outermost
clearance point of STILE 27 at least 80 cm
from combustible and/or flammable
material. If this distance cannot be
maintained, a thermal protection should be
arranged (UNI 7129, UNI 10683).
Do not approach or touch the outer surfaces
of the combustion chamber with flammable
material as it can reach high temperatures
following continuous use.