ULTRASTOR ULTRA 12F24, Руководство по установке

Страница: 11 / 52

g. Insert the controller card into any AT slot in the system and secure the
board with a bracket screw.
4.0 Software Installation
There are three steps for software installation:
1. Low Level format using the ULTRA 12F24 on-board BIOS utility.
2. Disk Partitioning using the FDISK command under DOS.
3. High Level format or surface scanning using the operating system’s
format command.
After following the hardware installation according to the above instructions, the
following steps need to be taken before the low level format:
a. Turn on the system power and boot up DOS on floppy drive "A" (Floppy
drive "A" should contain DOS system diskette to boot.). SETUP programs
and AT ADVANCED DIAGNOSTIC programs are not required to add the
ESDI drive to the system CMOS RAM. However, in system setup, make
sure that the hard drive is specified as "installed". (Type 1 can be used.)
b. Load DEBUG program (or SID for DR DOS) from floppy drive "A" by
typing:
DEBUG
after the DOS prompt "A" sign.
c. Once in the DEBUG program, following the prompt "-" sign, type the
appropriate BIOS address to which the board is jumpered.
EXAMPLE:
g=C800:5 (if the board is jumpered to C800:0) OR
g=CC00:5 (if the board is jumpered to CC00:0)
d. The UltraStor "Utility Main Menu" will appear on the screen (See Figure
2.0). In order to do the low level format, the drive parameters need to be set
up first. The main menu allows users to enter both the "Drive Parameter
Set Up Menu" and the "Drive Preparation Menu".
Reference Manual Page 9