7
The RAS/RAM- MT is a magnetically mountable contact probe with cable. The probe is applied to a test
surface and the RAM (Remote Access Module) is plugged into the front end of the Ultraprobe.
RAM/RAS-MT: REMOTE MAGNETIC TRANSDUCER
3.
ACCESSORIES
A. STANDARD ACCESSORIES
HEADSET
This heavy-duty headset is designed for use with or without a hardhat and can block out intense sounds
often found in industrial environments so that the user may easily hear the sounds received by the
ULTRAPROBE. In fact, these headphones provide over 23 dB of low frequency noise attenuation.
:
WTG-1 WARBLE TONE GENERATOR
The WTG-1 Tone Generator is an ultrasound transmitter used to validate the sensitivity of an Ultraprobe
before and at times after an inspection. For details on the Sensitivity Validation test, see Appendix A:
Sensitivity Validation Test. The Warble Tone generator may also be used for specialized tests such as
when it is difficult to produce pressure or draw a vacuum floods an area with ultrasound which will flow
through a (usually) large leak area. By scanning with the Trisonic
TM
Scanning Module, empty containers
such as, bulkheads or hatches can be instantly checked for leakage.
:
RUBBER FOCUSING PROBE
The Rubber Focusing Probe is a cone shaped rubber shield. It is used to block out stray ultrasound and to
assist in narrowing the field of reception of the “Trisonic" Scanning Module.
:
STETHOSCOPE EXTENSION KIT
This consists of three metal rods that will enable a user to reach up to 31 additional inches (78.7 cm) with
the Stethoscope Module.
:
This Ultraprobe 15,000 uses a lithium ion battery. A full charge will take about 4 hours, however you may
charge the unit at any time for short intervals or for a longer period. If it is kept on charge over 4 hours,
there will be no harm to the battery.
NOTE: When the effective battery charge is used up the
instrument shuts down and a message to recharge the battery will be displayed in the display panel.
BATTERY (2)
:
BCH-10 BATTERY CHARGER
This is the battery charger for the UP-15,000. It works with both 120 VAC, 60 Hertz and 240 VAC, 50
Hertz and comes with multiple plug adaptors for different countries. The charging time is about 4 hours.
There are two plugs: Black for the main pistol housing and Yellow for the WTG-1 Tone Generator.
:
UE- BATTERY CHARGER POD
This is a Battery Recharge Pod docking station for charging Ultraprobe Batteries (Lithium Ion only). This
pod will charge the standard batteries that come with the Ultraprobe 15,000 while removed from the
metered pistol housing.
:
RAM/RAS-MT Magnetic Mount Transducer
