EN – 28
Shining BLUE
Battery is charged
None
Flashing BLEU
battery is being charged
None
Off
Battery of the device is completely flat or
the device is switched off
Charging the battery or switch
on the device
(section
2.3.7).
Table 7: LEDs
2.3.7
Battery
The integrated batteries in the PABLO® Sensors can be charged via the PABLO® Charger
included in the scope of supply. Because this charging unit has been tested as a medical
device, the Pablo® Sensors are also electrically safe during a charging process. Follow
the instructions, however, about the use of the device during a charging process.
The use of charging units that have not been recommended by
TYROMOTION GmbH is expressly forbidden, because unforeseen risks
could arise for people and equipment.
Charging Battery:
In order to charge the batteries, first connect the PABLO® Charger to a plug and then
put the PABLO® Sensors onto the charging sockets destined for the sensors. The PABLO®
Sensors switches into the charging mode automatically (Note the LED display described
in Chapter 2.3.6).
PABLO® Handsensor und PABLO® Motionsensor must be fully charged before being used
for the first time
Figure 11: Correct positioning of the Sensors
