EN – 33
3.4
Preparation of the PABLO® system
1.
When the PABLO® system is supplied, the integrated Sensor batteries are
uncharged. Before first use, charge the batteries according to the description in
section 2.3.7. Then proceed as described here.
2.
Connect the Bluetooth connector to the USB extension and then to a free USB
port of your PC and follow the installation instructions of your PC.
3.
Install the driver for the Bluetooth connector (the driver for this device is included
in the scope of supply and is automatically recognized by Windows). For the
operating systems Windows 7, Windows 8 and Windows 10 an exact description
of how to proceed with the settings is included in the scope of supply.
4.
Start the tyroS® software by double-clicking on the tyroS® symbol on your
desktop.
5.
The PABLO® system connects itself to your PC automatically via Bluetooth
technology as soon as you start a therapy session with the PABLO® system. Please
note the LED display on the PABLO® Handsensor and the PABLO® Motionsensor
(Chapter 2.3.6). This gives information on the current status of the PABLO®
system.
As the PABLO® Sensors for wireless communication via Bluetooth use a
similar bandwidth to Wi-Fi, the signal may be lost occasionally.
3.5
Preparation of the PABLO® Handsensor
In order to prevent any therapy disruption as well as damage to the PABLO® Handsensor,
the sensor can be attached to the patient’s hand with the hand strap included.
1.
Take the PABLO® Handsensor, the wrist strap and the finger strap and place
them in front of you. Make sure the PABLO® Handsensor is positioned with the
on-symbol visible on the top.
