F4000 LCD Operator's Manual
Document No: LT0117
Operating Instructions - Zone Functions
Page 7-14
19 April 2002
Issue 2.38
7.4.3 OPERATING SEQUENCE - ZONE RANGE
From the base display, press:
to reset zone numbers n n n to m m m. This command can also be used on networked
zones - refer to Section 2.5.1 for network zone number entry.
For networked zones the LCD will display the network zones with a message saying
"Network Command Sent". After a brief period the message should change to "Network
Command Accepted".
Refer to Section 2.5.6 for more details on these and other possible LCD display messages.
If an exception occurs at the remote FIP, then an exception display may be received
indicating the type of exception. Refer to Section 2.5.7 for a discussion of Exception
Messages.
IMPORTANT The range of zones entered at an F4000 must be limited to zones on a single
networked FIP, i.e. the range cannot encompass zones on more than one
FIP.
