TV One C2-7000 Series, Руководство пользователя

Страница: 60 / 120

C2-7000 S
ERIES
O
PERATION
M
ANUAL
54
automatically default to Ethernet and control via RS-232 is disabled whilst that
connection is maintained.
Enter 4 numbers one by one to form the IP address you wish to assign to the
unit. The IP address is a series of four numbers between 0 and 255. Anything
above 255 is not a valid number in an IP address range. The unit will not allow
you to go above 255.
The IP address must be a unique address on your network, and also must be
within the sub-net of your network. If you are unsure about which IP address
to use or don’t have a unique IP address, ask your Network Administrator.
Adjust the last 2 numbers to set the sub-net address (also know as sub-net
mask) of your network. Again, if in doubt ask your Network Administrator.
Enter your network’s gateway IP address into this menu item. Again, if in
doubt ask your Network Administrator. In general, the gateway only needs
setting if the unit is being controlled from a different network (e.g. via the
internet).
Enter the IP port number you wish the unit to communicate on. Keep a note of
this as it will be needed when using other devices to communicate with the
unit e.g. CC-300.
Certain units require a re-boot once the new IP address has been entered.
Once activated, all current settings (including other menu items) will be saved
and the unit will re-boot.
8.14 Items associated with the Adjust resolutions group
The Adjust Resolutions Menu Group only appears when
the Advanced Menus function is turned on within the
System Menu Group. To turn it on, go to the System Menu
Group and then proceed to the item that says “Advanced
Adjust ethernet
IP add. [ 10] 1 2 123
Adjust ethernet
IP sub. 255.255. [255.000]
Adjust ethernet
IP gtwy. [ 10] 1 2 123
Adjust ethernet
IP port [10001]
1A Adjust Ethernet
Set new IP data & reboot